A bottom feed or siphon feed airbrush works best when putting airbrush art onto a t-shirt. You should always stick with a name brand airbrush when airbrushing. The best name brands to go with are the Iwata or Badger. The Paasche is also a good quality airbrush to go with. You will save yourself money in the long run when using a name brand versus a generic airbrush. These of course are just the tip of the iceberg when it comes to publications that have featured her work. Shanteau does not just create brilliant airbrush art, she also teaches others how to create the same high quality airbrush art that she herself creates. In February of 2002 she released the book, The Ultimate Airbrush Handbook. By discussing your techniques and sharing your insight you will show your audience that you are an artist that knows what they are doing. Once you have a couple of post up telling about yourself and showing off some of your work then you are ready to get your blog seen by the world. Some blog sites such as Shout Post and Tblog actually show your blog posts off for you to other bloggers. You will need a air compressor that is designed for airbrushing on nails. The best air compressor to use is the Iwata Studios Series Silver Jet Air Compressor. While this one is the best one you can go with any small compressor that has an 18 psi. Preferably get an air compressor that will adjust between 10-18 psi if you do not go with the Iwata Silver Jet. Make sure to oil your airbrush up before putting it back together. Most artists find the using their airbrush without the needle cap gives them more control. Removing the needle cap is fine but should you hit your airbrush against something or drop it you could end up damaging the needle itself. So to take care of your airbrush make sure that when you are not using your airbrush that you replace the needle cap back onto it. No matter what material you go with make sure that you remember to cut out your areas slowly. By taking your time you can make sure that everything matches up the way it should. If you are doing a stencil for say a dog then you would want to take your time and make sure that the eyes were the same size, the nostrils were cut out shaped the way they should be and so on.